2000w fiber laser cutting machine in the cutting as long as the correct operation generally will not be much problem, and cutting effect is also better. If there is a burr hanging slag when the equipment is processed and cut, then attention needs to be paid attention to, and it is the key to find out the cause of the problem and solve it in a timely manner.
How do burrs come about?
In fact, burrs are excessive residual particles on the surface of metal materials. When the 2000w fiber laser cutting machine in the processing of workpieces, the energy generated by the laser beam irradiating the surface of the workpiece vaporizes and evaporates the workpiece surface to achieve the purpose of cutting. But here’s a device that we need to pay attention to, which is gas.
Gas is when the workpiece irradiates the surface gasification, blows off the slag on the surface of the workpiece, if the gas is not used, the slag cools, will form a burr attached to the cutting surface. Therefore, the purity of the gas is high, can be replaced by a higher quality gas supplier, the purity of the gas is critical, do not use cylinder gas, because after two fillings, the purity is not good, but also waste of gas.
Another reason is the quality of the equipment itself, there is a parameter-setting factor, so when the customer buys a laser cutter, let the experienced operator debug the equipment. So try to adjust the cutting parameters to the best, air pressure flow focal length cutting speed or what, to go through a number of adjustments, relying on the parameters provided by the machine is not cut high-quality workpieces.
If a material has burrs, then the material can be qualitatively inferior, the more burrs, then the quality will naturally be lower
In general, when a 2000w fiber laser cutting machine appears a burr, it can be checked and solved in the following areas:
1, the output power of the 2000w fiber laser cutting machine is not enough.
Solution: Check that the laser cutter is working properly. Abnormality requires timely repair and maintenance. If it is normal, check that the output values are correct.
2, the focus of the beam’s upper and lower position skews.
Solution: Adjust the position of the focus and adjust it based on the offset position it generates.
3, cutting machine gas purity is not enough.
Solution: Change gas.
4, cutting machine’s wire cutting speed is too slow.
Solution: Adjust the wire cutting speed in time.
5, the laser beam of the cutter added point has been offset.
Solution: To debug the focus and adjust it in a timely manner.
2000w fiber laser cutting machine is a sophisticated machine, often a data error will cause its work to not work properly, so the work should be tight, and reduce errors.
Some small problems are likely to lead to the 2000w fiber laser cutting machine gland hanging slag factors, so I hope that we can solve this problem when faced with this.
2000w fiber laser cutting machine in the cutting as long as the correct operation generally will not be much problem, and cutting effect is also better. If there is a burr hanging slag when the equipment is processed and cut, then attention needs to be paid attention to, and it is the key to find out the cause of the problem and solve it in a timely manner.
Learn more about our products, please visit and subscribe to our Youtube channel
